Breadcrumbs

  1. Forums
  3. DIscussions
  5. Tech Help
  7. Looking for a set of prints

Looking for a set of prints

  • Danny McGee
  • Topic Author
30 Jan 2021 15:42 #1 by Danny McGee
Replied by Danny McGee on topic Looking for a set of prints
Mine is 5035

Please Log in or Create an account to join the conversation.

More
30 Jan 2021 14:41 #2 by Matt Gunsch
Replied by Matt Gunsch on topic Looking for a set of prints
What serial # is your G ? Mine is 5046
A&P, IA, PPSEL
too many years GA and Warbird Maint
Check out the Ercoupe Discussion group on facebook

Please Log in or Create an account to join the conversation.

More
26 Jan 2021 15:24 #3 by Ronald Raty
Replied by Ronald Raty on topic Looking for a set of prints
Drawings for the 415C can be found here. Many of the parts were the same through all the models.

www.ercoupe.info/mobile/pmwiki.php/Main/Drawings

Please Log in or Create an account to join the conversation.

  • Danny McGee
  • Topic Author
25 Jan 2021 17:06 #4 by Danny McGee
Looking for a set of prints was created by Danny McGee
I am starting the rebuild of a 415G, looking for a set of prints that identifies the specs of each part mainly the type and thickness of the aluminum used. So I can use the right material to make the part.

Please Log in or Create an account to join the conversation.

  1. Forums
  3. DIscussions
  5. Tech Help
  7. Looking for a set of prints
Time to create page: 0.092 seconds
Powered by Kunena Forum