Ercoupe 3D Files

It's on this website. Look under Documents->Miscellaneous->STL

I've put together some 3D models (.stl format) of an Ercoupe. One is a complete Ercoupe, but it's very difficult to print on your typical printer because there are no flat spots to put on the print bed. So I split it into halves. Now I can print the halves then glue them together. It makes for much nicer models. I use supports (touching buildplate) because of the main landing gear and the vertical stabilizers. Those parts are very delicate, so I use very light supports (like 8% density). The trick is to get the supports off without damaging the MLG or vertical stabilizers. It's possible! 

There is also a version with a loop on top for hanging I'm attaching a picture of the one I printed using glow-in-the dark filament that I use as a pull on a light over our kitchen sink.

Since I can't attach an .stl file here, I'm asking the webmaster to put it in the documents folder. Look for the .stl files there.

Hope someone can have fun with these!!