Breadcrumbs

  1. Forums
  3. DIscussions
  5. Tech Help
  7. General
  9. Bleeding the Brake Lines

Bleeding the Brake Lines

More
01 Nov 2021 18:44 #1 by Matt Gunsch
Replied by Matt Gunsch on topic Bleeding the Brake Lines
The bleed fitting is on the opposite end of the caliper from the brake line, usually a 1/4 wrench to open and close. easiest way to bleed is with a pump oiler fitted with a section of clear vinyl tubing that fits tightly on the oiler and bleed fitting.
A&P, IA, PPSEL
too many years GA and Warbird Maint
Check out the Ercoupe Discussion group on facebook

Please Log in or Create an account to join the conversation.

  • Larry McCartin
  • Topic Author
01 Nov 2021 16:10 #2 by Larry McCartin
Replied by Larry McCartin on topic Bleeding the Brake Lines
Thanks for asking. Cleveland.

Please Log in or Create an account to join the conversation.

More
31 Oct 2021 10:23 #3 by Matt Gunsch
Replied by Matt Gunsch on topic Bleeding the Brake Lines
what brake calipers ? goodyear or clevelands ?
A&P, IA, PPSEL
too many years GA and Warbird Maint
Check out the Ercoupe Discussion group on facebook

Please Log in or Create an account to join the conversation.

  • Larry McCartin
  • Topic Author
30 Oct 2021 19:40 #4 by Larry McCartin
Bleeding the Brake Lines was created by Larry McCartin
I just had to add Brake fluid to my Coupe for the first time in 6 years. It is a 1946 415-C. I can't seem to find the bleed screw on the back plates of the landing gear. With a car it is usually a nut with a hole in it for bleeding. Any advise? Regards, Larry  N93436 Grants, NM

Please Log in or Create an account to join the conversation.

  1. Forums
  3. DIscussions
  5. Tech Help
  7. General
  9. Bleeding the Brake Lines
Time to create page: 0.141 seconds
Powered by Kunena Forum