Breadcrumbs

Coupe Capers - Wanted

More
23 Aug 2021 19:46 #1 by Matt Gunsch
Replied by Matt Gunsch on topic Coupe Capers - Wanted
I don't recall the name, I have not done much with warbirds for a while, only one I have been working on recently is a T-28 with a intermittent ignition issue, it gets your attention when a 1820 at 1800RPMs backfires.

A&P, IA, PPSEL
too many years GA and Warbird Maint
Check out the Ercoupe Discussion group on facebook

Please Log in or Create an account to join the conversation.

More
23 Aug 2021 15:44 #2 by Warren Hampton
Replied by Warren Hampton on topic Coupe Capers - Wanted
Please Email @ This email address is being protected from spambots. You need JavaScript enabled to view it. your address so I can send Eariiy Capers to .you. Keep or pass on...

Please Log in or Create an account to join the conversation.

More
23 Aug 2021 15:39 #3 by Warren Hampton
Replied by Warren Hampton on topic Coupe Capers - Wanted
Matt, do you know Tony Wiser ? He too works on Warbirds live in Phx also . works mostly in Southern Cal. P 51s , t 28s,and T-6s mostly

Please Log in or Create an account to join the conversation.

More
23 Aug 2021 11:25 #4 by Matt Gunsch
Replied by Matt Gunsch on topic Coupe Capers - Wanted
I am in Phx AZ

A&P, IA, PPSEL
too many years GA and Warbird Maint
Check out the Ercoupe Discussion group on facebook

Please Log in or Create an account to join the conversation.

More
23 Aug 2021 01:13 #5 by Warren Hampton
Replied by Warren Hampton on topic Coupe Capers - Wanted
Matt, I am up in the Reno, Nv area Where are you?

Please Log in or Create an account to join the conversation.

More
18 Aug 2021 18:48 #6 by Warren Hampton
Replied by Warren Hampton on topic Coupe Capers - Wanted
Larry I have some old Coupe capers and I am missing a few late ones where is the list of what you have? found them,.Need an update of w
what you have now. Warren Hampton This email address is being protected from spambots. You need JavaScript enabled to view it.

Please Log in or Create an account to join the conversation.

Time to create page: 0.098 seconds
Powered by Kunena Forum